Tiburon · Belvedere · Tankless Water Heaters

Tankless Water Heater Installation & Repair in Tiburon & Belvedere, CA

Navien or Rinnai install typically $4,800–$6,900 before any gas line upsizing · exact price in writing after a free site visit · standard tankless repair $350–$850 .

New Navien and Rinnai tankless heaters, tank-to-tankless conversions, error-code repairs and yearly descaling for homes across the Tiburon peninsula. We check the gas supply and the vent route before we quote, pull the Town, City or County permit, and leave the heater set up for easy service.

★★★★★ 5.0 on Google · 340+ reviews C-16 & C-36 Lic #1091739 Navien & Rinnai certified

Serving Tiburon, Belvedere and Paradise Cay from our San Rafael shop and Sausalito office · Tiburon plumbing · Belvedere plumbing

Wall-mounted Navien NPE-240A2 tankless water heater installed by Local Plumbing in a Tiburon home
5.0★ on Google · 340+ reviews
Gas supply checked before we quote
Town, City or County permit pulled
Free written estimate first

Water heater out? Call or text (415) 234-0370. We’ll give you a written price before we start.

One ZIP code, three permit desks

Every address on the peninsula reads 94920, but the permit for a new tankless heater can come from three different offices. We work out which one before we write the estimate, because each has its own rules about what we can do and when.

Town of Tiburon

A long inspection list

Tiburon requires a building permit for a water heater replacement and takes applications by email. Its water heater handout lists what the inspector looks at: seismic support, venting, gas shutoff and sediment trap, pipe insulation, bonding, the condensate drain, and the expansion tank. Smoke and CO alarms have to be in place before the inspection is signed off.

City of Belvedere

Permits even for maintenance

Belvedere requires a building permit for all repairs and maintenance to plumbing and mechanical systems, not just new installs. Most exterior changes also go through Design Review, so a new vent cap on a visible wall is something we raise early. Work runs 8 a.m. to 5 p.m., Monday to Friday, and that window includes deliveries.

Paradise Cay

County of Marin

Paradise Cay has a Tiburon mailing address but sits in unincorporated Marin, so its permits go through the County’s Community Development Agency. The roughly 200 homes there were built in the 1960s on bay fill, many with private docks.

Where tankless heaters end up on the peninsula

Belvedere Lagoon

1950s–60s homes, many rebuilt

The custom homes around the lagoon went up in the 1950s and 1960s, and many have since been remodeled or rebuilt. After a remodel, the heater is often far from where the original gas and water lines ran, so we trace both before deciding where the new unit should hang.

Belvedere Island

An older housing stock

Belvedere’s median home dates to 1959. The gas pipe to an older heater was sized for the tank it fed. A whole-house tankless burner such as the Navien NPE-240A2 fires at up to 199,900 BTU/hr, several times a typical tank, so we check the line before we quote.

Belveron

Single-story ranch homes

About 250 ranch-style homes built in 1950–51 on level ground. On a single-story house on level ground, the gas and vent runs to a wall-hung unit are usually shorter than on the hillsides.

Old Tiburon & Lyford Cove

Hillside lots above the water

When a hillside heater lives under the house, Tiburon’s rules for under-floor appliances call for an access opening of at least 22 by 30 inches, a work platform and a permanent light, which we check before choosing that spot again.

Tiburon generally

Mostly 1970s and newer

Tiburon’s median home was built in 1970. Some larger homes run two gas tanks to keep up with several bathrooms, and one condensing tankless unit can often replace both. That’s exactly what our April 2026 job below did.

Indoors over finished floors

Drain pans where a leak would do damage

Tiburon requires a watertight pan at least 1.5 inches deep, with a 3/4-inch drain, under any water heater where a leak could damage the building. We plan for one whenever the heater sits over living space or a finished floor.

What a Tiburon inspector expects to see

These items come straight from the Town of Tiburon’s residential water heater requirements. We build every tankless install in Tiburon, Belvedere and Paradise Cay to the same standard:

  • A shutoff valve with a fixed handle within 6 feet of the heater, serving only that appliance, and a sediment trap right before the gas inlet.
  • A 120-volt outlet within 25 feet for service, and a disconnect within sight of the unit.
  • PVC vent pipe glued with primer in a contrasting color, supported to the manufacturer’s spacing.
  • Every run of domestic hot water pipe insulated, and water, gas and other metal piping bonded.
  • An expansion tank wherever the home has a backflow device or another closed valve on the supply.

Tankless problems we fix on the peninsula

Rinnai Error Code 61

Means: a combustion fan motor fault.

We check the blower, the wiring harness and the board connections before ordering anything. On a Tiburon RUR199iN in June 2026, the blower itself turned out to be fine.

Rinnai gas valve failure

Found by: a diagnostic visit, not guesswork.

We order the factory gas valve assembly, overnight when needed, as on a Belvedere job in August 2026.

Navien error codes

Common: ignition failure, flame loss, fan faults.

We measure inlet gas pressure while the burner runs flat out, since a starved supply can look like a bad part. See Navien error codes explained.

Hot, then a burst of cold

Usually: a clogged inlet filter, a weak flow sensor, or a unit too small for the fixtures.

We clean the filter, measure flow, and size any replacement to how many showers run at once.

Long wait for hot water upstairs

Usually: a long pipe run from a heater under the house.

We fit a Navien A2 with built-in recirculation, or add a pump to an existing unit.

Never been descaled

Risk: scale on the heat exchanger and a spent condensate neutralizer.

We flush it with descaler and swap the neutralizer cartridge, like our October 2026 Tiburon service.

Tankless trouble in Tiburon or Belvedere?

Recent Tiburon and Belvedere tankless jobs

April 2026, Tiburon: two gas tanks out, one Navien in

This home had two A.O. Smith gas tanks standing side by side. We replaced both with one wall-hung Navien NPE-240A2 in the same spot, which freed the floor space and added recirculation.

  1. Both tanks removed
    We protected the floors along the access path before carrying out both old tanks.
  2. New copper and yellow CSST
    New gas and water lines were run in the space under the house to feed the new heater.
  3. New 2-inch PVC flue
    We strapped a new flue from the heater to the outside, on a route discussed with the owner beforehand.
  4. Isolation valves and recirculation
    Service valves on the hot and cold lines make the yearly flush quick. The NPE-240A2’s built-in recirculation keeps hot water close to the taps.
Two old A.O. Smith gas tank water heaters side by side in a Tiburon home before the tankless conversion
Navien NPE-240A2 tankless water heater installed over a drain pan in a Belvedere home
September 2026 · Belvedere

Navien NPE-240A2 over a drain pan

A new NPE-240A2 with a tankless service-valve kit, a stainless expansion tank sized for tankless, and a new gas connector with its own shutoff. The unit sits over a drain pan, so a future leak goes to the drain instead of into the house.

November 2026 · Belvedere

Bringing an outdoor unit inside

Our most recent Belvedere job replaces an exterior-mounted tankless heater with an NPE-240A2 on the inside face of the same wall. The scope covers rerouted interior gas piping, a 2-inch PVC intake and exhaust through the wall with a weather cap, and a new expansion tank.

June 2026 · Tiburon

Rinnai RUR199iN, Error Code 61

The code points to the combustion fan motor. Inspection showed the blower didn’t need replacing, which kept the repair smaller. Before leaving, we confirmed fan speed feedback, the ignition sequence and steady operation.

August 2026 · Belvedere

Rinnai gas valve assembly

Our diagnostic found a failed gas valve assembly on a Rinnai unit. We had the factory part shipped overnight and credited the earlier diagnostic visit against the repair.

Also on our tankless page: a two-unit Noritz system we installed for a large Tiburon home.

Tankless cost in Tiburon and Belvedere

These are the published ranges from our tankless pricing. Peninsula homes often have extras, such as a long gas run from the meter, heaters under the house reached by stairs, a vent that has to clear a deck, or two tanks to remove. We price those after seeing the house, and you get the number in writing before work starts.

$4,800–$6,900 Navien or Rinnai tankless installation
+$500–$1,200 Recirculation setup, built-in or external
$450–$2,500 Gas line upsizing, if the sizing calls for it
$350–$850 Standard tankless repair
$280–$450 Annual descale and service

Pricing varies with brand, access, venting and what the diagnostic finds. Removing the old tank is included in an installation.

Get a Free Estimate The written estimate is free.

Soft water, but descale it anyway

Tiburon and Belvedere get their water from Marin Water, and Marin Water is soft: about 3.5 grains per gallon from the Mt. Tamalpais reservoirs and about 6.5 from the Sonoma County supply. Scale builds slowly here compared with harder-water areas. A tankless heat exchanger still collects some, though, and a condensing unit’s neutralizer cartridge wears out regardless of water hardness.

Our premium annual service on a Tiburon unit in October 2026 is typical: a full flush with biodegradable descaler and a new wall-mount condensate neutralizer. The isolation valves we install on every new heater are what make that a short visit. More in our guide to annual tankless servicing.

Can I still install a gas tankless heater here?

Yes. Under the Bay Area Air District’s Rule 9-6, amended on November 4, 2026, the zero-NOx requirement reaches whole-house tankless heaters only for units manufactured after January 1, 2033. That covers instantaneous heaters over 75,000 BTU/hr, and a Navien NPE-240A2 fires at up to 199,900. Ordinary gas storage tanks (over 30 gallons, 75,000 BTU/hr or less) reach that requirement first, for units made after January 1, 2028.

  • Nothing changes for the tankless already on your wall: the dates only matter when new equipment is bought and put in.
  • Repairing the heater you already have is not affected.

Details in our Air District rule guide for Marin and Sonoma.

Thinking about a heat pump water heater instead?

We install heat pump water heaters too (not heating or cooling systems). MCE currently offers up to $3,000, or $5,000 for ultra-low-GWP models, when a participating contractor applies before the install. A heat pump needs room air and a drain, which an under-house spot on a hillside lot may not have, so we look at both options on the same visit. See our heat pump water heater page, and check current terms at mcecleanenergy.org.

How a peninsula tankless install runs

  1. Look first

    We follow the gas line from the meter, note every gas appliance on it, find a vent exit, and check whether the spot needs a drain pan.

  2. Written estimate

    You get one written price, with any gas upsizing, recirculation or relocation broken out.

  3. Permit

    Town of Tiburon, City of Belvedere (with a check on Design Review if the vent shows), or the County for Paradise Cay.

  4. Install day

    Floors protected, old heater or heaters out, unit hung, vent, gas, neutralizer, expansion tank and service valves in.

  5. Fire it up

    Gas pressure tested at full burner, recirculation programmed, temperature set.

  6. Inspection

    We book the final inspection and remind you that smoke and CO alarms must be in place for it.

Tiburon & Belvedere tankless FAQ

How much does a tankless water heater cost in Tiburon?

Our published range for a Navien or Rinnai installation is $4,800–$6,900, plus $450–$2,500 if the gas line needs upsizing and $500–$1,200 for recirculation. Converting from two tanks or moving the heater adds work, so we price it after a site visit, in writing.

Does Belvedere require a permit to swap a tankless heater?

Yes. Belvedere requires a permit for all plumbing and mechanical repairs and maintenance, and a vent cap on a visible exterior wall may also need Design Review. We handle the paperwork.

Can one tankless heater replace two water heater tanks?

Often, yes. In April 2026 we replaced a Tiburon home’s twin A.O. Smith tanks with a single Navien NPE-240A2. The gas line has to be sized for the larger burner, which we confirm before quoting.

Is gas tankless still allowed in Marin after the Air District vote?

Yes. Whole-house gas tankless heaters fall under the January 1, 2033 manufacture date in Rule 9-6, and existing heaters can keep running and be repaired.

My Rinnai shows Error Code 61. Do I need a new heater?

Usually not. Code 61 points at the combustion fan motor, and on a June 2026 Tiburon call the blower itself didn’t need replacing. A diagnostic tells you what actually failed.

How often should a tankless be descaled on Marin Water?

Plan on a yearly service. Marin Water is soft, so scale is slow, but the flush also lets us check the burner and filters and replace the condensate neutralizer when it’s spent.

Do you service tankless units someone else installed?

Yes: Navien, Rinnai, Noritz, Takagi and others. See our Navien tankless page for that brand.

We install and repair tankless water heaters across the Tiburon peninsula: Old Tiburon and Lyford Cove, Bel Aire, Belveron, Belvedere Island, Corinthian Island, the Belvedere Lagoon and Paradise Cay. Town pages: Tiburon and Belvedere. Heating with a boiler? See boiler replacement in Tiburon & Belvedere. Comparing heater types? Start at tankless water heaters.

Ready to go tankless?

Tell us what you have now, one tank, two tanks or an older tankless, and where it sits. We’ll check the gas line and vent route on site and give you a written price.