Marin · Sonoma · No-heat boiler calls

No-Heat Emergency Boiler Repair in Marin & Sonoma

Open 24/7, emergency service available · no-heat & ignition repairs typically $385–$850 · exact price in writing before work starts

Radiators cold, radiant floors cold, boiler showing a code or doing nothing at all? Local Plumbing fixes hot-water heating, not forced air: boilers, radiant floors, baseboard and the pumps, valves and controls between them. Run through the five checks below first. If the heat is still off, call or text and a licensed hydronic technician will track down the fault.

House cold right now? Call or text instead of booking online.

★★★★★ 5.0 on Google · 340+ reviews C-16 & C-36 Lic #1091739 Open 24/7

Dispatched from our San Rafael shop & training facility · All emergency services · Contact us

Wall-hung condensing boiler with its front cover off during a combustion blower replacement in a Mill Valley home
24/7 emergency service available
Same-day boiler service available
Hydronic only boilers, radiant & baseboard
Written price before the repair starts

No heat tonight? Call or text (415) 234-0370. Tell us what the boiler display says and whether the whole house or one zone is cold.

Five checks before you call

Some no-heat problems come down to a switch or a thermostat. These checks take five minutes, need no tools, and whatever you find helps us bring the right parts.

  1. The thermostat

    Make sure it’s set to Heat and turned a few degrees above room temperature. If the screen is blank, replace the batteries. If one room’s thermostat calls and others don’t, note which rooms are cold.

  2. The boiler’s power

    Most boilers have a service switch nearby that looks like an ordinary light switch and is easy to bump off. Check it, then check the breaker. A boiler with a dark display usually has no power.

  3. The pressure gauge

    A typical home hydronic system reads about 12–15 PSI when it’s cold. Near zero means water has leaked out, so don’t keep firing it. A high reading with water coming from the relief valve also needs a technician.

  4. The code or lockout

    Take a photo of any code or flashing light. One reset is reasonable. If it locks out again, stop. A boiler that keeps locking out is protecting itself, and repeated resets can make the fault worse.

  5. Any smell of gas

    Don’t touch the boiler or any switches. PG&E says to leave the area right away, call 9-1-1, then call PG&E at 1-800-743-5000. Call us once the gas is safe.

If the system has been off for months, read restarting a shut-down hydronic boiler before you turn it back on.

Is it an emergency, or can it wait for a booked visit?

We answer 24/7, but not every no-heat problem has to be fixed at midnight. Here’s how we’d triage it over the phone.

Call or text now

  • Gas smell anywhere near the boiler (911 and PG&E first)
  • A carbon monoxide alarm going off: get everyone out, and call 9-1-1 if anyone feels ill
  • Water spraying or pooling around the boiler, or the relief valve discharging
  • Scorching, sparking or a burning-electrical smell at the boiler or its controls
  • No heat at all with a baby, an elderly person or someone ill in the house
  • A boiler that also makes your hot water and has stopped doing both

Usually fine to book

  • Cold in a single zone or bedroom, warm everywhere else
  • Radiators warm at the bottom and cool at the top
  • Gurgling or ticking, but the house still heats
  • Pressure creeping down slowly over a week or two
  • A single lockout that cleared on one reset and hasn’t come back
  • A boiler you want looked at before the next cold snap
Call or Text (415) 234-0370 Not sure which column you’re in? Call and describe it. We’ll tell you honestly.

Real heating calls from the past year

From our own job records, anonymized: what was wrong, and what we did about it.

Viessmann Vitogas cast-iron gas boiler with a standing pilot in a Mill Valley home with radiant heat
Mill Valley · January 2026

A standing-pilot cast-iron boiler on a radiant system

This home has a Viessmann Vitogas 050 cast-iron gas boiler with a standing pilot, an indirect water heater, Uponor radiant manifolds and a Taco zone control. That’s four separate pieces of equipment, any of which can stop the heat. We worked through it from the flame back: the pilot and thermocouple assembly, the gas valve, then the 24-volt control circuit, metering each point against the boiler’s wiring diagram. It took two diagnostic visits. When a system has several controllers, we trace the fault before we replace any part.

Mill Valley · Dec 2025

Combustion blower failed

The combustion blower on a wall-hung condensing combi boiler had failed. That’s the fan that pulls in combustion air and pushes out exhaust, and the boiler can’t fire without it. The condensate pump needed replacing too.

We replaced the blower assembly and the condensate pump, cleared the condensate drain line with compressed air, resealed the cabinet, and ran a complete heating cycle to confirm clean ignition with no fault codes.

Petaluma · Oct 2026

Two zones dead, boiler fine

Two motorized zone valves had failed, and so had the 3-zone relay that tells the valves to open and the boiler to fire.

We installed two Caleffi Z-one valves and a Caleffi 3-zone switching relay, bled the air, then tested each thermostat one at a time. Every zone heated. Full write-up.

Novato · Oct 2026

Leak on restart, then a safety control

A hydronic system that had sat shut down sprang a pipe leak when it was turned back on. Once that was fixed, the low-water cut-off turned out to have failed.

We repaired the pipe with press fittings, pressure-tested it, purged every loop, then replaced the cut-off and ran a full start-up. Full write-up.

And in Kentfield this November: two radiant floor zones that wouldn’t warm up, caused by two failed zone valves. See what a Ross Valley boiler service turns up.

Cold house? We’re open 24/7.

How we run down a no-heat call

A boiler only fires when several things all say yes. We test them in the order the boiler checks them, so we find the actual break instead of guessing at parts.

  • Is anything asking for heat? We confirm the thermostat call actually reaches the zone control or relay. A dead transformer or a loose thermostat wire stops everything downstream.
  • Does the boiler have water and pressure? Low pressure, a failed low-water cut-off or a leak will keep a healthy boiler from lighting, as on the Novato job.
  • Can it light and stay lit? On older standing-pilot boilers that means the pilot, thermocouple and gas valve. On modern wall-hung boilers it means the blower, igniter and flame sensor, and a blocked condensate drain can shut them down too.
  • Is the heat getting to the rooms? Circulators, zone valves, radiant manifold actuators and trapped air. If the boiler is hot and the rooms aren’t, the problem is here.

Our boiler repair page covers the brands we see and the full diagnostic checklist. For radiant floors and radiators in general, see boilers & radiant heating.

Technician holding a boiler pilot and thermocouple assembly removed during a no-heat diagnosis

Fix it tonight, plan the rest later

On an emergency call, the first job is getting heat back safely. Whether the boiler should be replaced is a separate decision, and you don’t have to make it in a cold house.

Usually a repair

  • A zone valve, relay, transformer or thermostat wire
  • A circulator pump, air vent or expansion tank
  • A blower, igniter, flame sensor or condensate pump
  • A pilot assembly, thermocouple or low-water cut-off
  • A leak in accessible piping

Time to talk about replacement

  • The heat exchanger is leaking or cracked
  • Combustion can’t be brought into a safe range
  • It’s an orphaned Triangle Tube (the maker closed in November 2025) and the failed part can’t be found
  • The boiler has had several no-heat failures in one winter
  • It was ever under floodwater
$385–$850 No-heat & ignition repair, priced in writing after diagnosis
$1,200–$4,500 Pump, manifold & valve upgrades
$8,500–$15,000 High-efficiency boiler replacement

Published 2026 ranges. Every home is different. If replacement makes sense, see boiler replacement. On the gas rules: Rule 9-6 still lets us put in a gas boiler. After the Air District’s November 2026 amendments, its zero-NOx standard only reaches home boilers manufactured after January 1, 2033, and nobody has to pull out a boiler that works.

No-heat boiler FAQ

Do you do emergency boiler repair at night and on weekends?

Yes. We’re open 24/7 and emergency service is available across Marin and Sonoma. Call or text (415) 234-0370 and tell us what the boiler is doing.

Why is my boiler on but there’s no heat?

If the boiler is hot and the rooms are cold, the heat isn’t getting out: a stuck zone valve, a failed relay or circulator, or air in the loops. If the boiler is cold and its display is on, look for a code, which usually points to ignition, airflow or water pressure.

What should my boiler pressure be?

For most homes, about 12–15 PSI with the system cold. If it’s near zero, don’t keep running the boiler. Water is leaking out somewhere, and adding more only hides the leak.

Should I keep pressing reset?

No. One reset is fine. If the boiler locks out again, the safety controls have found something real. Write down the code and call.

Do you repair furnaces or air conditioning?

No. We work only on hot-water (hydronic) heating: boilers, radiant floors, radiators and baseboard. For a forced-air furnace, you’ll want an HVAC company.

How much does an emergency boiler repair cost?

Most no-heat and ignition repairs run $385–$850. It depends on what failed, so we diagnose first and give you a written price before the repair. Pump, manifold and valve upgrades typically run $1,200–$4,500, and a high-efficiency boiler replacement $8,500–$15,000.

Is it a bad idea to repair an old boiler?

Not if the heat exchanger is sound and the part is available. Many no-heat failures come down to one control or one pump. We’ll tell you if the boiler itself is near the end, and you can plan that replacement on your schedule.

Marin: Sausalito, Mill Valley, Tiburon, Belvedere, Corte Madera, Larkspur, Greenbrae, Kentfield, Ross, San Anselmo, Fairfax, San Rafael, Terra Linda, Lucas Valley and Novato. Sonoma: Petaluma, Penngrove, Cotati, Rohnert Park, Sonoma, Glen Ellen and Santa Rosa. More: boiler repair · boilers & radiant · boiler replacement · emergency plumbing · contact us.

Boiler down and the house getting cold?

Call or text with the code on the display and what you’ve already checked. We’ll take it from there.